Pусский
Español
Deutsche
Português
Black pvc dipped long protective gloves sandy finish
Shunxing glove manufacturer produces customized long black PVC impregnated gloves, 45 cm.
Used in chemical industry, electroplating, coating, oil field and machining.
Lining: cotton cloth
Quality control: strict quality control process, stable and good quality
Black pvc dipped long protective gloves sandy finish 18inches oil resistant glove
The surface of PVC impregnated gloves produced by Shandong Shunxing labor protection company is PVC synthetic rubber, the surface is black sand, and the inner lining is 45cm cotton. Oil resistant, acid and alkali resistant, can be customized according to needs.General introduction:The production line of impregnated gloves is mainly composed of main frame, heating system, transmission system, electric control system, air circulation mechanism, feeding mechanism and so on. Continuous production mode and direct immersion mode are adopted, with uniform film formation and bright color. The length of the production line is designed according to the requirements of the buyer.
water proof, Anti-acid-base | Place of Origin: | Shandong, China | |
MOQ: | 500dozen | Color: | black |
Material: | 70%pvc，30% cotton | Size | 45cm |
Lining | Cotton or Polycotton | Weight: | 330g |
Feature: | Oil Resistant, Anti-acid & alkali | Certification: | EN420, EN388 |
Supply Ability | 50000 Dozen/Dozens per Month | Packaging Details | 12pairs/polybag, 60pairs/carton |
Port | Qingdao/Shanghai/Shenzhen/Guangzhou | surface | sandy finish |
2. Introduction to production line process
Action flow of rubber impregnated glove host:
1. Preheating steps: preheat the abrasive tools through the oven.
2. Molding steps: manually put it into the cotton cloth.
3. Cooling steps: run for 1 minute.
4. Reverse frame steps: enter the reverse frame mechanism and reverse the frame automatically
5. Dipping steps: enter the PVC glue dipping cylinder, the full dipping frame goes down vertically, half dipping into 45 degrees, and the time is 5 seconds.
6. Dropping steps: after dipping, enter the dropping tank to drop. Dropping time: ① set according to product thickness, weight, requirements: ② weather temperature of the day: ③ glue viscosity, etc.
7. Heating steps: enter the oven and heat it with steam. The fan is used for hot air circulation in the oven, and the temperature can be controlled automatically.
8. Cooling steps: after vulcanization, drying and molding, the product goes out of the drying oven and enters the cooling section of the finished product.
9. Demoulding steps: manually take off the finished gloves.
10. Cooling steps: after demoulding, the mold enters the cooling section.
